Scaline Sync | Lossless Scaling | Page 1

glossy lion Oct 7, 2024, 7:09 PM

#

Lossless Scaling Has Been Impressive With His Current Updates.
But There Is A Thing That Needs A Fix
and That is Ghosting aka Scaline Sync.
When I Use LSFG That Gives A Smooth Gaming Experience But With A huge Drawback.
While Using It It Gives Smooth Frames But The Game Screen Starts Tearing From Edges If there is a Low Character Movement Sensitivity But If There Is a High Movement Sensitivity The Character and UI will also start Ghosting and edges tearing runs continuously

I DON'T KNOW IF I EXPLAINED PROPERLY OR NOT BUT WE LOSSLESS SCALING USERS NEED THIS ISSUE TO BE FIXED WE HAVE SEEN IMPROVEMENTS IN UPDATES AND BELIVE IN LOSSLESS SCALING TEAM THEY WILL LOOK INTO THIS MATTER AND TRY TO SOLVE IT.

hushed frost Oct 9, 2024, 9:36 PM

#

just Use Vsync or limit your framerate?

also ghosting is a physical display issue and tearing is a Syncing issue

tidal cradle Oct 14, 2024, 8:10 PM

#

glossy lion Lossless Scaling Has Been Impressive With His Current Updates. But There Is A Th...

You can inject scanline sync into LS with RTSS, though it's a bit tough to figure out.

Also, in case you are, I wouldn't be using LSFG above your refresh rate as that looks bad. Instead cap your game to 1/2, 1/3, or 1/4 your refresh for X2, X3, and X4 LSFG modes respectively.

#

Additionally, if you target something under your refresh rate, e.g. 130fps on a 144hz monitor, I'd recommend using variable refresh rate (VRR) such as freesync or gsync and setting Lossless Scaling's sync mode to "off". This solves tearing, has low latency, and looks absurdly smooth.

gusty hollow Dec 29, 2024, 7:01 AM

#

tidal cradle You can inject scanline sync into LS with RTSS, though it's a bit tough to figur...

hey can anybody guide me on how to set up the scanline sync? I am desperate to have the least amount of input lag while using lsfg.

tidal cradle Dec 29, 2024, 7:03 AM

#

gusty hollow hey can anybody guide me on how to set up the scanline sync? I am desperate to h...

I never managed to get it working properly. Your best option is to use VRR to handle the sync, and setting sync mode to "off" in LS

#

In that case, you need to target a framerate slightly (around 5%-10%) lower than your max refresh rate.

#

Personally, I cap my game to 53fps and use X3 to 159fps on my 165hz monitor.

gusty hollow Dec 29, 2024, 7:05 AM

#

I see unfortunately I dont have VRR supported monitor. So the best I can do is vsync (with much more input lag) yes?

zinc pewter Dec 29, 2024, 1:48 PM

#

This vs special K reflex? which is better

gusty hollow Dec 31, 2024, 9:53 AM

#

I dont even know how to set it up

#

the special K I mean

#Scaline Sync