It takes way too long to open up the map after launching like, seconds. I've missed maneuvers cause of that. I don't think it's just on my end as I'm getting good framerate and everything runs smoothly on that front. Any ideas?
#good fps, but what's with the map?
silver harbor
swift ridge
I think it's just the optimization right now. But hey, the tracking station loads INSTANTLY! because you use the tracking station on every flight mission, right, and frequently flip back and forth to it multiple times per mission right?
hasty cloud
err well actually i do in ksp, lmao.
As painful as it is, it's only because after 6 years i still have no no clue how to switch between active craft without using the tracking station!
Even have Easy Vessel Switch installed and still do it cos i'm just stupid! 😅
tardy haven
I think it's just the optimization right now. But hey, the tracking station load...
yea all the time!!
tardy haven
err well actually i do in ksp, lmao.
As painful as it is, it's only because aft...
use the square bracket keys if the craft you're switching to is close enough. ( "[" and "]" )
hasty cloud
use the square bracket keys if the craft you're switching to is close enough. ( ...
Ohhhh, you need to be close, like rendezvous close i take it? Off back to ksp1 now need to try this!
tardy haven
Ohhhh, you need to be close, like rendezvous close i take it? Off back to ksp1 n...
yea, if you can see the craft then i guarentee you can switch to it but exact distance im not sure
hasty cloud
Cool, thanks. That explains why i never bothered trying much. It says 'in range' which i always understood to mean comms range. Then when i could never swap between active craft going all over the place just gave up trying! cheers fella