Walksnail Goggles X Mount Rail for TrueRC X²-AIR 5.8 MK II PAIR FOR HDZERO

[lime sentinel]

This is a front rail system to mount the TrueRC X²-AIR 5.8 MK II PAIR FOR HDZERO VRX4 on Walksnail Goggles X.
Mirror it on your slice software to get the other side.

Here is the Antennas: https://www.truerc.ca/shop/5-8ghz-2/receiver-long-range/x²-air-5-8-mk-ii-pair-for-hdzero-vrx4

Download: https://www.printables.com/model/813913-walksnail-goggles-x-mount-rail-for-truerc-x2-air-5

[vestal kraken]

so I printed up a set of these last night... any chance you can mod thesefor use with the larger HDZero goggle adapters?

[lime sentinel]

I thinj it'll not fit on the goggles with these larger mounts from HDZero...

[prime oxide]

Thanks for making These cool stuff. I combing your Cover with the Patch mod from HDzero. Works really good, but with the Extrudr Greentec Filament, I had to do a lot of sanding.

[vestal kraken]

I did a remix of the larger HDZero goggle mounts to get them to fit your adapters.

I have modded them further in order to get both patches pointing more or less straight ahead (but I haven't taken a new pic of them)

also note that your adapters printed a tiny bit oversized on my printer. I reduced them them to just over 99% in the slicer to get them to fit properly.

[vestal kraken]

which patch mount did you use? Wouldn't mind trying out a pair of X2-Airs for long(er) range flights.

[prime oxide]

here the link:

https://www.thingiverse.com/thing:5544584

fits with TPU very well

[vestal kraken]

nice find.
how are the patches attached to the mounts? double-sided tape?

[prime oxide]

yes i have the 3m Tape.

but the X2 air comes with double tape

fits also good

[vestal kraken]

Thanks for the info... I'll order me up a pair of patches.

[fading blaze]

can you share you mod/design? thanks!

[vestal kraken]

Here you go.

[opal flicker]

The little clips used to fit in the holes are just too fragile because of their size, I think I'll make them stronger.
Otherwise they fit really nicely and look great on the goggles 👍

[lime sentinel]

I just mare some adjustments to fit perfectly… 👊🏻😎

Model updated on firts link.

[dense pulsar]

I tried printing these and had fitment issues where it didn't sit within the faceplate recess and also it wasn't deep enough between the rail mount and the base of the mount so it didn't sit within the recess enough

I modified them to fit better, which I'd be happy to share

[vestal kraken]

I had similar fitment issues. Scaling to 99.05% in slicer resolved them.