The ratios are good, the shapes are rotated before getting here but they're at full speed, i isolated those and got 100% but at this swapper platform is where one or two lanes cannot keep up
#There is a backlog in my factory but I cannot figure out why
urban ivy
junior thicket
are the two outputs of the swapper platform combined at a later point, for example with stackers ?
urban ivy
are the two outputs of the swapper platform combined at a later point, for examp...
theres another swapper platform after then stacker yes
junior thicket
then it's probably because there isn't exactly the same belt distances between the two swapper platforms, you can for example fix this by putting overflow splitters into trashes on those belts
lyric hawk
Or use I on the second platform
urban ivy
then it's probably because there isn't exactly the same belt distances between t...
im not sure i understand..? and can you elaborate on the overflow splitter pls?
lyric hawk
Can you show us the stats of the swapper
urban ivy
lyric hawk
I can only assume it’s because the right side is slightly longer than the left side due to the height differences
junior thicket
im not sure i understand..? and can you elaborate on the overflow splitter pls?
if the two sets of belts that link the two swapper platforms don't have the same length, then when one backs up it'll cause the swapper to back up and that will cause the other lane to back up, etc, putting overflow splitters on the two lanes with the overflow output into a trash will fix the issue, you can also alternatively redesign the platforms to have the swapper+rotators+swapper setup as one module that's repeated multiple times per belt
junior thicket
Or use I on the second platform
that will only fix the issue momentarily
urban ivy
if the two sets of belts that link the two swapper platforms don't have the same...
can you circle around on the screenshot pls to show what you mean? im having a hard time visualizing what you mean
junior thicket
this is what I mean by the two lanes
urban ivy
okay, so where do i put the overflow exactly? before or after the rotators
junior thicket
either way should work
urban ivy
okay ill try thx!!
urban ivy
either way should work
it works!!! tysm, i didnt even know how to use those. how shall i use them in future builds, everywhere? lol
junior thicket
for that use case, it's after the outputs of cutters and swappers, the other machines don't need it as they don't have multiple outputs