woven sphinx
<@&1122587817768398938> When 3D printing Polylight 1.0 LW-PLA with nozzle temp 230°C, bed temp 50°C, 20% fans, 0.5 extrusion multiplier, I get these issues on this particular wing. Can someone give advice please, I really dont know how to fix this. I tried lowering the fan speed as well as changing it higher. I printed at 240°C, etc.
benchy looks like this
misty crane
That looks wet to me
woven sphinx
is there a way to dry it?
olive lichen
Definiteyl seems wet! You can see the oozing.
PLA-LW will anyways string a little bit more and have a bit of a rougher surface though
woven sphinx
Okay, but is there really no way to dry it without a filament dryer or food dehydrator
serene sandal
Mm doesn't look like moisture to me, LW-PLA is just really stringy. Especially this one because you picked up the active foaming one from 3D Lab Print as opposed to Polymakers PolyLite LW-PLA which is preformed.
woven sphinx
Okay that sounds good, but it will get wet sometime and I dont have a Filament dryer or a Food dryer, cant I dry it at all?
vague folio