I have a spool of PA-612 on order and a X1C that will be here Thursday, I'm hoping to get an idea of what profiles have worked well for people printing PA-612 on a X1C. It seems like the bed temps required are quite low but I know that chamber temps for most nylons can have a pretty big effect on layer adhesion and warping, so I was thinking I can preheat the chamber with the side blower and the bed for 15-20min before printing but I wanted to check with what everyone thinks.
#PA-612 BambuLabs X1C Filament Profile
minor quartz
vale tide
The 612 is still technically in beta so results will vary but I'm pretty sure @peak junco has printed with it and can share his results with you.
A good starting point is the printing info on the website and if you find something that works well, be sure to share it for others!
tidal garnet
I have a spool of PA-612 on order and a X1C that will be here Thursday, I'm hopi...
PA-612 is very easy to print. No need to preheat the chamber. Actually it's recommending to leave the door open on your X1C. It's like printing PLA but with a nozzle temp of 290c.
Here's my profile for your X1C.
peak junco
Sideline prints a lot more of it than I do. I actually use his settings for it
tall jolt
The 612 is still technically in beta so results will vary but I'm pretty sure <@...
To clarify, the beta isn't for the material. Nico shared on stream that the beta is just for the marketing. The product description etc will be dictated by the customer feedback.
vale tide
To clarify, the beta isn't for the material. Nico shared on stream that the beta...
I must have misunderstood that. Thanks for the clarification