#ASA on Textured PEI sheet (Glue or not)

7 messages · Page 1 of 1 (latest)

red brook
#

I just did my first ASA print with my Bambu X1C and it worked perfectly using the Engineering Plate with glue. I red somewhere that it's possible to use the Textured PEI sheet without any glue with ASA. However, on the Prusa material table, they wrote that glue is required for textured PEI. Anyone tried it and can confirm if it works or not? I don't want to put glue on my textured sheet.

astral portal
#

I've been printing multiple items in ASA on my X1C with the textured PEI sheet without any adhesion assistance. I've been using the Generic ASA filament profile

red brook
slate wadi
#

I also used ASA on the textured PEI without glue or anything and it worked perfectly

#

Good adhesion and basically popped off on its own once it cooled down

crude basin
#

I agree with @slate wadi and @astral portal .. I print many ASA parts and don't need any glue... Only time I need a little extra is long thin parts that I can't use brims with. Then I use a little Aquanet as I don't like the glue residue on my parts.

haughty crag
#

Mine sometimes warp without gluestick. But maybe that's just me.
Also raising the bed temperature helps. I use 105 degrees.