3d-printer
circles print with a .5mm inaccuracy
Problem with cardboard spool and AMS Bambulab
squeeking v wheels!
anycubic mono x and wash and cure plus lid lifter
any one upgraded a sidewinder x1 or x2 to klipper with accelerometer
Post Klipper upgrade tuning of prints. something isn't quite right
How clean does the Bambulab X1 print - and alternatives?
should i fix my printer or buy a new one
Biggest printer blob
linear rail lubrication and general care discussion
My filament is weird
Ender 5 has arrived. What mods are good for an educational environment (such as side panels etc)
too good to be true???
layer gap issues (I think)
How is the ender 5S1 and does anyone here have one?
Running klipper on Orange Pi Zero 2
Can I use cardboard spools in the AMS?
Bad extrusion nozzle clog
Printer will not pause print or allow a filament change+
looking into a Klipper conversion for my CR10S Pro V2, any help or guidance is greatly appreciated
easy to remove supports on pursa
Input shaper and belt tension
Z quality issues
resin recommended for anycubic photon mono x 6k
ender 5+ cross braces?
can i use the anycubic airpure for a normal fdm 3d printer
Ender 5 Plus, BTT GTR 1.0 mainboard, BTT 5 Touchscreen