Hi, I just built my QK75 (wired hotswap ANSI) and noticed that I can’t fully finish it with my Matcha R1 set as only R2 has the stepped Caps Lock key that fits properly with where the Caps switch is on the board. Is it possible for me to be sent out or buy just the Caps Lock key, or would I have to buy the complete set again? I hope not the latter but I understand if so. Thank you!
#Any way to get a stepped Caps Lock for Matcha R1
blazing grotto
muted oxide
we only sell individual keycaps in the form of replacements, and only if the keycap exists within that particular basekit.
from what i'm seeing, the qk75 pcb should be able to fit the standard caps lock, you'll have to insert your switch to the right side.
blazing grotto
I see now, I was a bit confused about the way the switch fit into the plate when I was building it, tested it by flipping it 180° and it worked great, thank you so much!