#No stick input on betaflight after firmware update. Flight controller is Super F405HD (betaflightf4(

1 messages · Page 1 of 1 (latest)

stone plank
#

Maybe you selected the wrong rx protocol?

hoary palm
#

protocol is crsf. The flight controller has inbuilt elrs which is default to uart2

stone plank
#

Just double check it and flash the board again with the right rx protocol settings in the building configuration window.

hoary palm
#

the official website says its beflighF4 firmware. So, i guess its correct. https://www.happymodel.cn/index.php/2024/01/05/super-f405hd-elrs-aio-3in1-flight-controller-built-in-uart-2-4g-elrs-and-20a-esc-for-hd-whoops-25-5x25-5mm-mount-hole/

Happymodel
Jason
Super F405HD ELRS AIO 3in1 Flight controller built-in UART 2.4G ELR...

The Super F405HD ELRS AIO flight controller comes with integrated UART 2.4GHz ExpressLRS receiver and 20A Blheli_s ESC(Bluejay firmware pre-installed) which could support 3-4s battery. Bigger Mosfet could support high to 20A currents and reserved 6 pin socket for DJI HD equipment plug and play. It’s a great solution of build 3-4S HD digital FP...

#

it was the gyro which wasnt detected. i just figured it out. thanks