#Beitian BN220 ZF not recognized by FC (Speedybee F405 V3)

6 messages · Page 1 of 1 (latest)

clear crow
#

Hi I build a new GPS into my drone for Failsafe mode, but the FC doesn't comunicate with it. Its connected to UART6. According to the manual blue light indicates its communicating (blue light is flashing so I guess its turned on). But red light isn't flashing (so no 3D position). Also the GPS Icon in Betaflight is not turned on, what makes me think its not connected. Does anybody know how exactly I can get this to work?
https://store.beitian.com/products/beitian-gps-module-with-antenna-ubx-m10050-gnss-chip-ultra-low-power-gnss-receiver-for-track-be-220?variant=44695995449631&srsltid=AfmBOorjdnV7gJ8S5Wd9cgGmDAvm4eRv3WrjqWGejCn2CdLCvkFaWmOR

image.png image.png
Beitian store
Beitian BN 220 Drone GPS Module With Antenna Ultra-low Power UAV PIXHW

Comparison of eighth, ninth and tenth generation modules Model：BE-220 BK-220 BN-220 GPS Module BE-220 Feature： Chip:M10050 Frequency:GPS LI CIA. QZSS L1 CIAS,BDS BII/B1C. Galileo E1B/C,SBASL1 C/A: WAAS, EGNOS, MSAS, GAGAN Operating mode:GPS+BDS+GALILEO+SBAS+QZSS Sensitivity: Track:-166dBm Re- arest:-160dBm Cold start:-

fossil ice
#

Do you have your gps configured on the ports tab, gps enabled on the configuration tab, and the gps tab configured properly?

clear crow
#

yes I think so

#

This are the current configurations

Betaflight2.jpg Betaflight1.jpg
fossil ice
#

There is a third place you need to enable gps, in the configuration tab.

clear crow
#

I know I did