#Visual Beeper constantly but unsure why

1 messages · Page 1 of 1 (latest)

errant birch
#

Got a Mobula 8 PNP (analog) that I am getting a constant visual beeper (four asterisks) though it seems to fly just fine. Only things I have done are soldered RX, setup modes/switches, otherwise completely stock. It only does this when battery is plugged in though, not when only USB. The cell volts are well within the limits as well. No blackbox so cannot log. Looking for any other ideas to check (other than piece of tape over check engine light)

status

MCU F411 Clock=108MHz (PLLP-HSE), Vref=3.31V, Core temp=59degC
Stack size: 2048, Stack address: 0x2001fff0
Configuration: CONFIGURED, size: 3994, max available: 16384
Devices detected: SPI:1, I2C:0
Gyros detected: gyro 1 locked
GYRO=ICM20689, ACC=ICM20689
OSD: MAX7456
System Uptime: 97 seconds, Current Time: 2024-06-12T03:06:43.129+00:00
CPU:43%, cycle time: 125, GYRO rate: 8000, RX rate: 249, System rate: 9
Voltage: 718 * 0.01V (2S battery - OK)
I2C Errors: 0
SD card: Not configured
Arming disable flags: CLI MSP

version

Betaflight / STM32F411 (S411) 4.3.0 Jun 14 2022 / 00:48:04 (229ac66) MSP API: 1.44

config: manufacturer_id: HAMO, board_name: CRAZYBEEF4DX, version: edcd244b, date: 2022-06-29T02:24:46Z

board: manufacturer_id: HAMO, board_name: CRAZYBEEF4DX

random burrow
#

check if this mode is not setup correct

image.png
#

or check for other warnings in OSD tab

image.png
errant birch
#

So I found this had shipped with some rate profile switches setup under Adjustments that were conflicting with the mode switch. I was testing and in Aux 4 low for Angle mode the visual beeper was not trigger, but was in Aux 4 high for Acro. Rate Profile adjustments had default settings for both Aux 4 and Aux 2, conflicting. Disabled those and so far in bench testing the visual beeper has not returned. No idea why they would have set that unless it was a return, though it looked factory sealed.