pastel star
I have a RM Pocket and Tinyhawk 3. Sometimes the drone/FC doesn't respond to my SB switch for acro/angle/horizon. In Betaflight all the other sticks and switches respond but not Aux 2. But sometimes after a power cycle, it does work, without having changed anything. I thought it may have been caused by having Permanent Air Mode enabled (Configuration tab) but have now disabled it without solving the issue. Is there some other conflict or reason that would cause Aux 2 to not respond to any input?
This is my status output:
MCU F411 Clock=108MHz (PLLP-HSE), Vref=3.29V, Core temp=35degC
Stack size: 2048, Stack address: 0x2001fff0
Configuration: CONFIGURED, size: 3755, max available: 16384
Devices detected: SPI:1, I2C:0
Gyros detected: gyro 1 locked dma
GYRO=ICM20689, ACC=ICM20689
OSD: MAX7456 (30 x 13)
BUILD KEY: 3b5525dfcdf295e96fae12b2395c8369 (4.5.0)
System Uptime: 295 seconds, Current Time: 2024-05-07T04:16:35.024+00:00
CPU:32%, cycle time: 126, GYRO rate: 7936, RX rate: 49, System rate: 9
Voltage: 0 * 0.01V (0S battery - INIT)
I2C Errors: 0
GPS: NOT ENABLED
Arming disable flags: CLI MSP
pearl trail