So I built a cinebot 30 a while ago and has flown fine in the past, I'm using dji controller 2, with dji o3, and the Axisflying Argus F7 AIO F722 40A, brought it with me on vacation, start the drone, controller, goggles, seems to bind, but my pre arm and arm switches do nothing, fortunately I brought my laptop, installed BF, connected to it. And everything is working perfectly. So I just hit saved, unplugged, back to square 1. I have the LEDs set to come on once it's pre armed, disarmed they should be off they are on, I've checked modes, ports. Can't figure out wtf is going on and why inputs from the controller only seem to be working while the FC is plugged into the comp. Any help would be greatly appreciated 🙇🏻
#Drone responds only while USB connected to BF
charred heron
stuck flame
LED_STRIP is known to be misbehaving, if you are using this, recommend trying without.
if not, are you on 4.5-dev? if yes, then there is also an arm-blocking issue with a recent PR (by design).
need more info, which version and maybe a support-id or build-key from CLI.
afterward, maybe more people can help.
charred heron
Yes, I had assigned led_strip 1 A08. And had assigned user 1 to activate A08. Yesterday while running CLI:resources I did notice Led_strip missing from the list..
Newest version of BF 10.10.0 RC2. The FC came with blue Jay preinstalled. I can hook up to the drone now and get w/e info you need. How do I disable or change Led_strip since it no longer shows up under resource?