pilot w/ SpeedyBeeF405v3 gyro failure

[dapper vortex]

Confirmed it's a SPEEDYBEEF405V3.
was working from factory.
flashed 4.4 and 4.5 but no gyro.
core-build saw no gyro as well 😬 🤷‍♂️
no backup diff was created prior.

initial ticket via github: https://github.com/betaflight/unified-targets/issues/1146
photos in github last comment (.zip)
also seen video of it flying prior to upgrade.

Pilot is @urban yew .

version
Betaflight / STM32F405 (S405) 4.5.0 Sep  8 2023 / 16:30:50 (5cd2ab50e) MSP API: 1.46
config rev: 09f53ae
board: manufacturer_id: SPBE, board_name: SPEEDYBEEF405V3

status
MCU F40X Clock=168MHz (PLLP-HSE), Vref=3.30V, Core temp=58degC
Stack size: 2048, Stack address: 0x1000fff0
Configuration: UNCONFIGURED, size: 3776, max available: 16384
Devices detected: SPI:0, I2C:1
Gyros detected: locked
, BARO=DPS310
OSD: MAX7456 (30 x 13)
BUILD KEY: 28cae2d9e33cc69298816caf06a1977c (4.5.0-zulu)
System Uptime: 49 seconds, Current Time: 2023-09-08T16:43:21.350+00:00
CPU:0%, cycle time: 0, GYRO rate: 0, RX rate: 0, System rate: 9
Voltage: 2 * 0.01V (0S battery - NOT PRESENT)
I2C Errors: 0
SD card: Startup failed
GPS: NOT CONNECTED, NO PORT, NOT CONFIGUREDunknown
Arming disable flags: NOGYRO BOOTGRACE CLI MSP

[dapper vortex]

@urban yew , is this a solder blob?

this is what i see on the internets

[urban yew]

No its not a solder blob its seems like a coating preventing from water damage or something like that

[dapper vortex]

okay. thanks

[urban yew]

Like I said its a very new board that I just tested on

And there have no short circuits in the board

There is no*