chilly musk
Hello everyone, i have a trivial question to ask but i m a beginner and i haven t found anything around, i have a Speedybee f405 v3 to which i mounted a gps on the uart 3 taken on Amazon ( Seamuing ) i haven t tested outside but on betaflight i see it and it seems to go, unfortunately it does not have a compass, so always on Amazon i took the Gy-271 which i connected to the sda and scl ports but when i connect the dronei don t see it in betaflight. i followed some tutorial to configure the CLI like the various Mag hardware sets but i couldn t get it to work. Is it possible to have separate modules or do you need to have the compass integrated into the gps? Entering CLI Mode, type 'exit' to return, or 'help'
Building AutoComplete Cache ... Done!
status
MCU F40X Clock=168MHz (PLLP-HSE), Vref=3.27V, Core temp=45degC
Stack size: 2048, Stack address: 0x1000fff0
Configuration: CONFIGURED, size: 3678, max available: 16384
Devices detected: SPI:1, I2C:0
Gyros detected: gyro 1 locked dma
GYRO=BMI270, ACC=BMI270
OSD: MSP (30 x 13)
BUILD KEY: f272004be76cc6ea43807e17c7e4b2cf (4.4.0)
System Uptime: 28 seconds, Current Time: 2023-02-22T17:53:29.969+00:00
CPU:14%, cycle time: 315, GYRO rate: 3174, RX rate: 15, System rate: 9
Voltage: 67 * 0.01V (0S battery - NOT PRESENT)
I2C Errors: 1
SD card: Manufacturer 0xfe, 3817472kB, 09/2023, v1.2, 'ASTC'
Filesystem: Ready
Arming disable flags: RXLOSS CLI MSP MOTOR_PROTO
trail elm