I just built my new hyte y70 pc and am rocking a MSI RTX 4080, I also have two Samsung LS28AG700N monitors set to 3840 x 2160 143.86Hz. I connected the hyte y70 and it was detected but disabled. I only seem to get it working whenever I unplug one of the samsung monitors. I feel like I have tried everything from reinstalling drivers, plugging different ports, lowering refresh rates and resolutions, reboot after reboot and nothing it simply only works with one monitor + y70 display not the three at a time. Any help is greatly appreciated
#HYTE Y70 Touchscreen detected but no display
split star
solid swan
Sounds like you are exceeding the bandwidth limit of your gpu
If you have an iGPU i recommend utilizing it to lighten the load
split star
how would I do that if both monitors and the hyte are on display port?
simply swapping one of the monitors to hdmi?
solid swan
Easiest way would be swapping one of your main monitors to HDMI. Alternatively you can get an active converter HDMI to miniDP cable for the y70 screen
Active cables have an additional USB cable to power the onboard conversion chip
A 3rd option is getting a cheap low profile GPU and installing it in your half height horizontal slots
split star
I'll test the hdmi swap for my monitors and order the cable combo, do you mind if I check back with you when it arrives tommorrow?
I swapped one of my monitors to HDMI1 and plugged it both into the remaining hdmi port on the gpu and the motherboard and it still gets detected but no display output
nevermind, I rebooted and had the monitors source set to display port, It works now
my only issue is having that one monitor connected to the motherboard other than the gpu
getting the cable and connecting the touchscreen to the motherboard seems more viable to do correct?