volume move stuck at 98% fabricpool | NetApp | Page 1

glossy leaf Jul 11, 2024, 6:19 PM

#

Volume move completes 98% at a expected speed but getting stuck at 98% which keeps delaying the cutover.

The volume in question is tiered to fabricpool.

Does anyone experience this problem?
Is there any workaroud to get over this?

urban orbit Jul 11, 2024, 6:44 PM

#

that can have many reasons. For example heavy client-side I/O or open CIFS sessions.
Usually you can force the cutover, but I would check the event log and vol move show -instance for clues on why the cutover was delayed

glossy leaf Jul 11, 2024, 6:55 PM

#

I can force it but forcing might end up in a outage right , I don't want that to happen

And it just says cutover_hard_deferred.

elder parrot Jul 11, 2024, 7:12 PM

#

https://kb.netapp.com/on-prem/ontap/Ontap_OS/OS-KBs/Issues_with_Volume_move

NetApp Knowledge Base

Issues with Volume move

This flowchart helps you with solving issues related to moving volumes in ONTAP 9. The flowchart covers issues that may arise in any of the three stages of moving volumes - (a) before you move a …

#

Yeah the transfer can't complete in the timeout window.

fast saffron Jul 11, 2024, 7:22 PM

#

did this just start? it will keep trying to cutover. Maybe give it a day (maybe you already have?) and it might find a lull in activity where it can cut over in the requisite amount of time

urban orbit Jul 11, 2024, 7:41 PM

#

yeah, if it doesn't finish I would just force the cutover at some point when activity is low. it's no worse than forcing a takeover (i.e. I/O freezes for a couple seconds)

glossy leaf Jul 14, 2024, 5:25 PM

#

If force cutover is there any estimate time which I can expect it to be completed??

elder parrot Jul 22, 2024, 2:21 PM

#

Don't think so.

#volume move stuck at 98% fabricpool