This error seems to be halting all progress. I am not a server tech, but the "hey you" guy. If someone could Barney style a fix for this I would appreciate it. FAS2552. On tap 8.3
#Auto-partitioning disabled on this system.
acoustic coyote
I thought I made progress with setenv raid.autopart true, but then the message popped up later
reef python
how many disks are in the system?
and... what's the parter node say ?
acoustic coyote
24? Loader A and B are identical
woeful solar
how many disks are in the system?
and... what's the parter node say ?
4a would fix the ownership, right?
woeful solar
24? Loader A and B are identical
Is there any data on the system or do you just wanna full send reset it?
reef python
4a would fix the ownership, right?
I think 4a was removed in 8.x. But 4 will zero out the disks.
Later versions of 9 has 9a/b/c which makes enabling and disabling adp on init easier.
reef python
If it’s a wipe new. There’s a few things to do though.
acoustic coyote
Is there any data on the system or do you just wanna full send reset it?
Full send, complete rebuild
I finally got the server team to give me a hand on Tuesday. I'm the cybersecurity guy but finding out I'm gonna be a bit of everything. Our hardware is old and difficult to find support. I appreciate any help.
reef python
can you post "printenv" from LOADER-A and B> ?
reef python
And have you tried an opt 4 from each node?
acoustic coyote
I'll get the printenv this morning. Option 4 from the boot option? Yes. Both end right back at the screenshot above with the auto part error
acoustic coyote
woeful solar
When it boots you should see "Ctrl+C to Maintenance Menu" and that's where the option 4 is
feral onyx
And you’re got the other node sitting at the loader? What model disks are in it?
reef python
might be worth booting in to maint mode to see a few things. (boot opt 5)
check disk ownership, remove ownership, remove any existing partitioning. etc..
frozen arch
I would boot into maint. mode, delete all aggregates from both controllers, remove ownership from all disks and try again. Usually the system should pick up the right number of disks if they are all unassigned
acoustic coyote
What if I swapped out all 24 hard disks with a netapp we arnt using? The other netapp is missing a loader.
What if I pulled the loader out of this one I'm trying to fix and throw it in the one that is missing it? Is it plug and play?
feral onyx
if it's the same model, you'll need to run option 7 I think, load config from disk
if it's a different model it won't work
acoustic coyote
All the same. I have 5 stacks. 3 "work," 1 caked with dirt I'm gonna clean eventually, and one might be just for parts. I'll check out the possibility of a swap in the morning. Really tired of trying to figure this out.
acoustic coyote
@feral onyx Also, are you referring to me swapping the disk or the loader?