We would like to enable fabric pool on one of our A300 systems. We plan to setup two S3 destinations on FAS2720. We also plan to setup snapmirror to the same two systems because one is of cause useless without the other... But it is even possible to configure two S3 buckets, or would you have to setup a fabric pool between the two FAS2720? And what is the procedure if one of the two S3 buckets were to fail? Another approach woud be to setup a snapmirror between the two FAS2720 and mirror the volumes that hold the buckets... not sure if that is even possible yet? Sorry if this is all listed in the manuals (which I doubt) 😉
#How to secure your fabric pools?
earnest bloom
earnest bloom
OK... so I found a bit in the manual... apparently you can issue a "storage aggregate object-store mirror..." and attach two S3 destinations to your primary aggregate... which is nice... You can control which object mirror is the primary one as well... which is also nice, as one of our FAS2720 will be local to the primary storage is connected with 10Gb where the other is remote on a slower line... I guess we are good to go on this...