#wanna become sub 20 help pls

6 messages · Page 1 of 1 (latest)

broken yoke
#

Also ignore my legs in the end pls my table is broken

oblique tapir
#
  1. by far your biggest weakness rn is cubeshape, since you already seem to know scallop/kite just practice and work on planning it fully in inspection (don't hesitate to look up a more efficient setup if you can't find a good one)
  2. learn full eo, it's only 7 cases and can save a second or two over using 2 algs for it
  3. if you have a bar flip at the end of the solve you can cancel into it - for example you could've done 1 0/0 -3/-1 -1/-5 2/6 0/ to save a couple of turns
  4. this isn't necessary for sub 20 but it helps to know a few extra tricks for EP, for example knowing that 1 0/-1 -1/-2 1/-1 -1/-2 1/-1 -1/ (or M2 U' M2 U' M2) can be used to cycle top layer edges or 1 0/-1 -1/-2 1/-1 -1/4 1/-1 -1/ (or M2 U' M2 U M2) does a z perm can help with unlucky cases
    ^also note that these can be mirrored to the bottom layer easily
broken yoke
#

Thank you so much for the indepth explanation. I will be sure to follow these tips. Once again, tysm bcus i want break the nr for squan and im working on it so this rlly rlly helpsYOOCubenew 😁

broken yoke
#

Also may i ask, can you give me tips to improve my turning speed? @oblique tapir

oblique tapir
#

just minimize regrips and drill algs since most of the solve will just be executing algs