#Should I replace the thermal pads?
59 messages · Page 1 of 1 (latest)
don't
the one on the heatsink seem fine just keep them on
Ok then thanks
what are you repasting with??
How to mark it as solved post in flairs
Thermal grizzly kryonaut
Ptm is THE MUST
.
PTM7950
Noted
It even lasts like yes
U have to do 3 cycles for full potential
20mins 80C - 20mins less than 45C
For 3 times
I just googled it. That's a thermal pad right?
This is a thermal paste
In
So should I apply those pads instead of paste?
I thought you're supposed to put those pads only in those designated area
I wouldn't touch the vram chips
By stress test?
Ye
Noted
It's been months since I played any games. I ran llama3.1
Didn't know that could melt the thermal pads
I'll research on that
Once again thank you for your guidance
Which dimensions should I go for
@dim shale @warm copper
It's ptm7950
On Amazon it's around 27 usd so I found this online store where I found this in a reddit post
40*80
Thanks
40*40 would also be enough
but idk just feels good to have more when it's not really expensive anyway
40x40 is around 9 usd with shipping
Is one enough?
Before purchasing I'll check local stores as well