Good evening y'all. Got a bit of a weird one for you, I started noticing this issue a while ago and basically have rebuilt the printer since but the issue persists. Started with an ender 5 and now it's a full on beta frame zero g with an m8p. Basically at random times the printer will stop printing mid print, sit where it stopped with nozzle temp dropping but fan still running( mostly noticed after waking up so it's been hours since it's "shut down" tried 2 different power supplies wired/rewired everything to make sure that all is "right". There has been so much rewiring/mods done since the issue started that it doesn't make sense to list it all. At this point I'm basically just asking for guesses as to what is wrong so I can try new solutions. I've posted my config multiple times so I'm fairly certain that isn't the issue but if you want that im happy to give that. I'm just at a loss other than replacing the board (m8p w/cb1)
#Random print issue
sturdy thunder
graceful blazeBOT
Ahoi @sturdy thunder!
It looks like you did not provide all the necessary information we need to help you.
Please upload your logfiles and a detailed description of your problem.
For further information see: https://docs.mainsail.xyz/faq/getting-help/discord#provide-information
Note: We only accept .log and .txt files as log files.
This is an automated message
sturdy thunder
here is the current log. not completely sure how to read them. its mid print as of the pull but I have to cycle the power switch when the issue happens so I'm not sure the error code is saved
heavy flower
Send the log with the error. There should be other logs with timestamps. Send the latest log with timestamp
sturdy thunder
Hopefully this has it. Did not even realize you could do that
heavy flower
Best would be to reproduce the issue again and then download the log right after the crash
If klipper just stops, stays in one position, but the fan is going, it's in an error state. It should show you some error or similar with a red or yellow panel
I cannot find anything inside your logs right now
sturdy thunder
the problem is that when it crashes the klipper screen goes dark and does not display anything and i can no longer get to the website from my computer, therefor i have no way of seeing if its throwing an error. I have to power cycle the printer in order to get the screen back at which point the error is gone. im printing something now with the electronics enclosure off and it seems to be working, im wondering if the 2209 stepper drivers are getting to warm and causing the shutdown? I have fans blowing on the drivers and cb1 but the driver fans sit close enough to the lid that when i stick my hand at the level the cover would sit i can feel a little suck from them
