#shifted bed

8 messages · Page 1 of 1 (latest)

rain hare
#

I have a problem, after switching to the clipper I noticed a certain problem, the bed is slightly offset in the X axis, this is most likely caused by the fact that the limit switch is not located perfectly above the edge of the bed, but is slightly moved, which is why the second values ​​that were set in the slicer were center, they are slightly shifted to the left on the printer. Anybody know how to fix it?

image.png 456210267_4003921969933343_6721243851363840093_n.jpg 455698565_2368006396880306_8105170892444323086_n.jpg
green crystal
#

What exactly is your question and problem right now?

#

A fix for your slicer?

#

A fix in klipper?

#

I can see that you moved the endstop to -6 on the x axis, so I think you are asking on how to change the slicer back?

spare quartz
#

the line is clearly not on your printarea:

image.png
#

your bed starts at the first white line. a prusa has a smaller printarea than bed. in your case, this is outside of your bed.