I just set up klipper on my Ender 3 V2 Neo using KIAUH, and a Pi 3B, and midway through my first print it just stopped with no error message, here are my logs
#Crashed Mid Print
rose viper
untold starBOT
Ahoi @rose viper!
Welcome to the Mainsail support-forum!
There is a problem with the tags you selected for this post. Please fix them to fit your question.
For further information on tags please check the readme: #readme message
To change the tags of this post:
- Open the
...menu on the top right corner of this post. - Find
Edit tags - Select the checkbox of the correct tags.
Usually you just need to select one tag!
If you still have no idea which one to choose, feel free to ask here.
Note: This is an automated message
Thanks for your cooperation!
hardy delta
there is an error message in your your log and this should also be displayed in the webinterface:
Transition to shutdown state: Lost communication with MCU 'mcu'
and when this error comes, you have to press "firmware restart" in the gui to restart the printer again.
rose viper
I know how to restart my printer, I was wondering if there was anything clueing you into what caused it to lose communication
hardy delta
I know how to restart my printer, I was wondering if there was anything clueing ...
this was, because you wrote:
and midway through my first print it just stopped with no error message
so i just wrote "there was an error message"...