chilly bluff
Recently installed mainsail, klipper on a linux laptop to run my printer. On the dashboard, when I change the temps of the bed and hotend, I see the gcode command and it raises each to that temp, then as soon as it does, it reverts back to the temp that was in the dashboard previously.
Is this normal? and if so, how to a make the temp stay at what I entered for that session?
untold waspBOT
Ahoi @chilly bluff!
It looks like you did not provide all the necessary information we need to help you.
Please upload your logfiles and a detailed description of your problem.
For further information see: https://docs.mainsail.xyz/faq/getting-help/discord#provide-information
Note: We only accept .log and .txt files as log files.
This is an automated message
exotic forge
without any log, nobody can help you...