Reverse dir_pin result in negative prope_calibration

[charred shuttle]

Ahoi @onyx hawk!
It looks like you did not provide all the necessary information we need to help you.
Please upload your logfiles and a detailed description of your problem.
For further information see: https://docs.mainsail.xyz/faq/getting-help/discord#provide-information
Note: We only accept .log and .txt files as log files.
This is an automated message

[noble sandal]

A postive z offset would mean that you have to increase your z position to get to the probe

Overall the values that you get from that macro should be correct

Or did you test and it resulted in a way wrong z position?

[onyx hawk]

If I use the macro, it gives a positive value in the window, but when it's saved to the config, it's saved as a negative value, resulting in an error

I'll take some screenshots, sec

[noble sandal]

Not at my pc, I might have messed up in my head again

But you most likely get an out of range error, right?

Then you should decrease the position min of your z

Don't try to be smarter than a macro a lot of people are using daily

[onyx hawk]

No no, not trying to be.

[noble sandal]

But removing the sign in front of it, looks like that ^^

So try to set position_min: -1 in your stepper_z section

[onyx hawk]

Alright

[onyx hawk]

Alright. So I basically removed all auto configurations, and started from scratch. That seems to have done the trick.

Also set the position_min to -1 as you suggested

[lime crystal]

What is the difference between the ! And ^!

?

I see this carrot ^! And I don't know when to use this