main thunder
So I have recently swapped over to Klipper on my ender 5 plus. It has a BTT SKR Mini E3 board. I haven’t been able to get the CRTouch to work. It turns on and cycles through twice but then the light stays a solid red. I am fairly confident that everything is plugged in correctly, I’ll attach a picture for reference, and I have used a few different pre-made printer.cfg. The one I am currently using will start the homing process and I have to stop it because the bed will keep rising without the probe down. I am fairly new to all this and have only been printing for about a year. Typically I can find online what my mistake is but everything I have looked up I’ve tried and still gotten the same results. Note: I did buy a BLTouch as well to make sure it wasn’t the sensor and it has the same issue. Any help would be greatly appreciated!
lean herald