weird action during QGL

[mint dock]

My printer does a strange “ jump” during QGL I’m at a loss of where to even start to diagnose it everything looks ok it was out of commission for a while had a power failure and that’s when I noticed issue I don’t know if they have anything to do with each other but figured I’d mention

[wide wind]

If I had to make a guess, it's an electro-mechanical related issue, sounds like one of the motors is unhappy and stops for some reason. Even if you had a weird QGL config where a corner was inset from the rest, Klipper would only take a direct path to it, not go most of the way on one axis, then take a path across both.

[stone ivy]

Ahoi @mint dock!
It looks like you did not provide all the necessary information we need to help you.
Please upload your logfiles and a detailed description of your problem.
For further information see: https://docs.mainsail.xyz/faq/getting-help/discord#provide-information
Note: We only accept .log and .txt files as log files.
This is an automated message

[wide wind]

Oh, and I'd count driver current settings under electro-mechanical issues, a bad setting there will cause those issues.

[mint dock]

@wide wind so the weird thing is when it did that i let it run a file and print came out fine no issues at all

litterally everything was aces one day and shit the next lol

and now when it goes to zero z its missing the switch almost same distance it jumps \

[wide wind]

I'd really check the belt path for what would be the right motor for issues, assuming that it's the same as a Voron. Can't tell if the belting is the same with the motors being upside down in comparison.

The one motor is stalling at least.

[mint dock]

should have lead with that its a voron 2

but would this happen over night ?