wet leaf
Hello,
My machine is rooted and installed with the Guilouz method.
So I have all the updates for klipper, mainsail, etc..
I made a Bed Mesh of 49x49 by deactivating the mesh_pps and you can see the result....
I have no idea what I could do to improve, knowing that the bed is fixed on this printer ( delta ).
elder magnetBOT
Ahoi @wet leaf!
It looks like you did not provide all the necessary information we need to help you.
Please upload your logfiles and a detailed description of your problem.
For further information see: https://docs.mainsail.xyz/faq/getting-help/discord#provide-information
Note: We only accept .log and .txt files as log files.
small pike
That looks extremely are you sure that there is nothing under the flex plate
wet leaf
Yes, I cleaned everything before making the mesh. To do some tests, I switched to 15x15 with mesh_pps:2,2 and I get a horizontal surface. With 9x9 and mesh_pps: 4x4 too.
I'll put up a screen when I get home from work.
small pike
Why you do 49 x 49? I can test that on my machine too biut that is a nextrem amount of points for a small bed?
thats a point distance of 6-7 mm. You would need "bend" in your flexplate that you would see an effect
small pike
Also paste your bedmesh section of that 49x49 setup so that I can understand what you really have made and also verify it on my machine
wet leaf
Ok here is my bed mesh in 15x15 with mesh_pps: 2.2
speed: 100
horizontal_move_z:30
mesh_radius: 147
mesh_origin: 0.0
mesh_pps: 2.2
round_probe_count: 15
algorithm: bicubic
bicubic_voltage: 0.1
move_check_distance: 3
zero_reference_position: 0,0```
the result is on the attached screen
For mesh in 49x49
```[bed_mesh]
speed: 100
horizontal_move_z:30
mesh_radius: 147
mesh_origin: 0.0
mesh_pps: 0.0
round_probe_count: 49
algorithm: bicubic
bicubic_voltage: 0.1
move_check_distance: 3
zero_reference_position: 0,0```
small pike
Ok I will run the same tomorrow at mine.