Title explains the most of it, images attached
#Tuning freshly Klipperized printer, getting very bad layer shifting during testing
odd topaz
Slicer speeds attached even though it shouldn't matter since I am using the Resonance Compensation test that increases accel by 500 every couple of layers
limber panther
Pls Post also your Klipper Log, that we can see your current default values.
limber panther
Title explains the most of it, images attached
Did you print this print with a tower function?
limber panther
Klippy is enough for this issue
odd topaz
Did you print this print with a tower function?
Correct. That's what I've been saying. Seems my max accel is hard stuck at around 4500~
limber panther
But in the worst case, just post both (if you are not sure which one is needed)
limber panther
Correct. That's what I've been saying. Seems my max accel is hard stuck at aroun...
Can you post the correct command and the height, where the issue begins?
odd topaz
Pressure advance turned off in slicer and console before print
TUNING_TOWER COMMAND=SET_VELOCITY_LIMIT PARAMETER=ACCEL START=1500 STEP_DELTA=500 STEP_HEIGHT=5
This is for the test tower
The original picture fails at the 3500 accel point
I changed the algorithm to EI in printer.cfg and made another with the same tower test and it now fails at 4500