Can't connect to my local web interface | Mainsail | Page 1

toxic mason Dec 10, 2023, 1:43 AM

#

Hi, this is my first time trying to setup this tech stack, so I'm not sure if this is the right tag. I just recently installed Mainsail, Moonraker, Klipper, etc on a Raspberry Pi 4B. Initially, the web interface worked fine but I couldn't connect to the printer and after a lot of troubleshooting, I found out I had to make the printer firmware on klipper to flash to my printer. I finally got that flashed and connected. That was sometime last week. I haven't done anything since then but when I came back today, my web interface isn't connecting. I can log into the pi locally but I'm not sure what to check on there to see if anything is wrong. Both my server name (I went with 3dprint.local) and the IP result in the same problem (attached screenshot). I'm not really sure where to go from here. I did a light googling but most people's problems I found were from several years ago and didn't seem the same as mine. I'm not sure I can get log files either, because WinSCP can't connect either, saying "3dprint.local does not exist".

fathom maple Dec 10, 2023, 6:01 AM

#

What means you can connect locally?

#

If that means you have a keyboard and monitor than start with ifconfig and check if it has an IP

toxic mason Dec 10, 2023, 5:41 PM

#

Yeah, I have a keyboard and monitor connected.

#

It's not showing the ip it had initially.

#

Which was 10.0.1.152.

#

rn_image_picker_lib_temp_c7e7d79c-607c-42f2-a7d8-47d639145423.jpg

#

This doesn't seem right to me.

fathom maple Dec 10, 2023, 5:55 PM

#

It shows no up at all

#

Is that a pi connected via WiFi?

#

Do you used MainsailOS

toxic mason Dec 10, 2023, 6:06 PM

#

Yeah, mainsail os. It's got an ethernet connection.

#

I blacked out some because they looked like public IPs to me.

fathom maple Dec 10, 2023, 6:08 PM

#

If it is connected via Ethernet check your router

#

Reboot the pi it should get an up doing that

#

Currently you have no ip at all that’s a problem of your local network

toxic mason Dec 10, 2023, 6:13 PM

#

I have rebooted it once, but yeah I can do it again. I'll see what I can find on the router. Unfortunately I don't have admin access right now.

#

Sigh, welp apparently it just needed another reboot. Lol. The web interface is back up. Thanks for your help!

#

Do I need to do anything to close this issue?

#Can't connect to my local web interface