Hello!, I changed my extruder for a biqu h2, and when it starts to print it purges filament on the side, but outside the bed, the same thing happens when it starts to print and the piece in the slicer is located in the middle of the bed, the printer does not print it in the center
#Problem with x offset
wet pond
boreal plume
Did you change your ABL Offsets? X and Y?
wet pond
noup, I don't know how to change them
boreal plume
Klipper or marlin?
wet pond
Klipper
boreal plume
Do you use ABL, right? If so, its on Printer.cfg
fluid nexus
If it starts the print on the wrong coordinates, your endstops are most likely not setup correctly. Home your printer and move the extruder nozzle to the point, where your 0,0 should be. Then adjust your endstop positions, inside your printer.cfg accordingly
wet pond
I do the home plate and then I put the nozzle inside the bed in the part where it should purge?
fluid nexus
No, put it at the position where your 0,0 should be to configure your endstops.
If your endstops currewtnyl at 0,0 but tthe position where you place the nozzle to be 0,0 is at 15,20, your endstops should be at -15,-20
fluid nexus
Can you send your printer.cfg?
wet pond
fluid nexus
Now change position_min of your stepper_x to -13 and your position_endstop to -13
For y you change it both to -25