and i have my probe on the left side
#move out of range!
peak cedar
inner shore
Hey, glad to hear that you figured out how to use your Spinda. I guess it's just a bad configuration of your [bed_mesh] section. For example your x_offset of your probe is -15 and your position_max for x is 260. If you now set mesh_max: 250, 250, it tries to move to 265 that your probe can get to 250.
peak cedar
so should i edit the mesh_max to 250, 250?
mesh_max: 220, 220 #190, 190 this is my mesh_max now
inner shore
What are your offsets of the spinda?
peak cedar
z_offset: 0.27
x_offset: -45
y_offset: 10
inner shore
Then your mesh_max for x should be a maximum of <position_max of x> - <x_offset>
peak cedar
so the x_max position should be the same as my x_offset?
inner shore
Send your printer.cfg
inner shore
mesh_min can be 0, 10 or higher
mesh_max can be 190, 235 or lower
With these values it would mesh the maximum possible size of your bed. mesh_min values can go higher and mesh_max values can go lower
peak cedar
i already have it sorry
inner shore
^^
peak cedar
im going to try it
so i have another problem 😬 my probe goes out of the bed, ill send a photo
inner shore
At the calibration? Then you should increase the mesh_min and decrease mesh_max. The values I sent are just the boundaries. You should increase/decrease them by 3-5.
inner shore
👍
peak cedar
your the best bro whenever i need help you respond!
inner shore
😎 👍