I was doing some speed and acceleration tests last night according to Ellis tuning. I got some crazy high speeds before I saw skipping.
Then I started paying attention to microsteps. No matter what speed or acceleration I test I always miss approximately 20 microsteps.
I use 16 in my cfg for my 0.9 motors and 1.0 run current.
Even in between homing from the end of one test to the start of the next I miss approx 20 microsteps when comparing the x and y coordinates.
Is this a non issue? I haven’t read anywhere in the docs to expect this
#missing microsteps
teal spade
silk tinsel
Please contact Elvis to talk about his test! If you ask me this test must loose steps in the way it is writen