soft vigil
Hi,
I just configure Pressure advance and resonance compensation, but I have one issue.
It's seems to be a hole where CURA put the steam of the printing.
I suspect some CURA configuration is not suppose to be active with klipper. I have coasting disabled, and acceleration control disabled.
Greetings!
lime flame
If that ridge is that deep your pressure advance is not right. Its probably set too aggressively. Remember, pressure advance can change wildly between filament types and even filament manufacturers of the same type. Thats why i set mine a tad lower and just deal with the littke bit of bulging vs needed a profile for every spool i have.
soft vigil
I have it at 0.1, after testing with the cube. Maybe retraction and Z-hope in CURA is the cause?