#Installing a Bootloader to Ender3pro Mainboard

2 messages · Page 1 of 1 (latest)

potent raft
#

In order to continue my install of Klipper, I need to have a bootloader on my mainboard. Which is a creality 1.1.4, which is a melzi board. My main board's processor is an Atmega1284p. I would like to install the bootloader using my Raspberry Pi 4's GPIO pins. I found this guide

https://web.archive.org/web/20210614024455/https://www.fission3d.com/post/flash-bootloader-and-install-firmware-with-raspberry-pi

I was wondering if it works, and also does the board need to be powered on while burning the bootloader. I really don't want to brick my mainboard, so any help available is very much welcomed, thank you

Fission 3D
Flash Bootloader and Install Firmware With Raspberry PI

​ Hi, in this guide you'll learn how you can flash a boot loader on your board using the raspberry Pi or similar. Hardware you'll need A PI (Any PI will do) 6 x female-female jumper cables ( Unless your pi does not have header then you need 6x female-male jumper cables ) Software You'll need Download and Install Putty https://www.chiark.greenend...

marble musk
#

Such things a better suite for a discord specialist on creative boards