keen dune
I recently did a large amount of mods to my cr10 including a second mainboard to run a stepper and some fans and everything was working well, and then I added a 24v 150w meanwell psu to run the secondary board containing all the hotend electronics since i have biqu hermit crabs on my printers so they can share hotends. After this change, I ran a calibration cube and it printed halfway and stopped extruding halfway but finished out as if everything was okay. After this any print I try will not make it past the purge line/skirt without giving this error. I switched wires to see if that would help and it didn’t, it went from right after the skirt to right after the purge line.
stiff crescent