Hello everyone
I am looking to get the HW-579 to work with klipper input shaping.
i can find the adx345 with sudo i2cdetect -y 1
any way to get this one working over i2c ?
Anything i got to change up in the printer.cfg ?
#Input Shaping with HW-579
earnest girder
obsidian helm
Hello everyone
I am looking to get the HW-579 to work with klipper input shapin...
pls doublecheck your tags: #readme message
and here you can find all supported resonance tester from klipper: https://www.klipper3d.org/Config_Reference.html#resonance-compensation
earnest girder
it is an adxl345
https://www.direnc.net/9-eksenli-imu-sensoru-gyro-yukseklik-ivme-hiz-en
i've wired it to the SCL/SDA, as the HW-579 doest have CS/SDO