DRV_STATUS error when print starts | Mainsail | Page 1

hot frost Jan 9, 2023, 12:31 AM

#

I keep getting an error message when the print starts:
TMC 'extruder' reports error: DRV_STATUS: 40160020 s2vsb=1(LowSideShort_B!) cs_actual=22 stealth=1

The printer will warm up and load the bed mesh. The extruder looks like it's trying to move but just jitters back and forth. I am not sure if they are related but my prints had incrementally become worse and got to a point where only one half was actually printing and the other half looked under extruded.

I have gone through the current calibration a few times to make sure it is correct so I am not sure what needs to be corrected. I am hoping it is not my motherboard as I replaced it 2 months ago.

Attached is the klippy.log

#

📎 klippy_1.log

languid oasis Jan 9, 2023, 5:09 AM

#

That’s an error of your tmc driver and indicates normally a short or broken wire

hot frost Jan 9, 2023, 5:26 AM

#

Thank you! I will take a look at the wires.

#DRV_STATUS error when print starts