sturdy mantle
I have been getting this error (picture). The klipper.log said thisTMC 'extruder' reports GSTAT: 00000001 reset=1(Reset)
TMC 'extruder' reports GSTAT: 00000000
Pausing toolhead to calculate extruder phase offset
Stats 113.1: gcodein=0 mcu: mcu_awake=0.003 mcu_task_avg=0.000012 mcu_task_stddev=0.000062 bytes_write=8187 bytes_read=24747 bytes_retransmit=9 bytes_invalid=0 send_seq=501 receive_seq=501 retransmit_seq=2 srtt=0.000 rttvar=0.000 rto=0.025 ready_bytes=0 stalled_bytes=0 freq=179999656 rpi: mcu_awake=0.001 mcu_task_avg=0.000009 mcu_task_stddev=0.000014 bytes_write=1305 bytes_read=6006 bytes_retransmit=0 bytes_invalid=0 send_seq=194 receive_seq=194 retransmit_seq=0 srtt=0.000 rttvar=0.000 rto=0.025 ready_bytes=0 stalled_bytes=0 freq=49997509 adj=49997463 heater_bed: target=0 temp=21.8 pwm=0.000 v1.1: temp=27.8 raspberry_pi: temp=31.2 Chamber: temp=21.5 sysload=0.78 cputime=6.269 memavail=3481212 print_time=131.776 buffer_time=0.000 print_stall=0 extruder: target=200 temp=201.0 pwm=0.290
TMC 'extruder' reports DRV_STATUS: 800f00d0 s2vsa=1(LowSideShort_A!) ola=1(OpenLoad_A!) olb=1(OpenLoad_B!) cs_actual=15 stst=1
Transition to shutdown state: TMC 'extruder' reports error: DRV_STATUS: 800f00d0 s2vsa=1(LowSideShort_A!) ola=1(OpenLoad_A!) olb=1(OpenLoad_B!) cs_actual=15 stst=1
Dumping gcode input 0 blocks. All wires are connected and have continuity. What am I missing? Should I swap wires?
balmy silo