nimble viper
Hello I am new here, I was hoping I can get help with an issue, I installed crowsnest after installing tailscale and 2 instances of klipper.
I keep getting make: *** [Makefile:37: install] Error 1
I have tried unistalling and get the same error, it won’t do anything other then provide the listed error. I am clueless now. Can you point me in the right direction
Thank you
icy torrent
Well, to help you, I need the full output of the error message. Error 1 only says that something went wrong, its a generic message of make command.
nimble viper
Thank you for looking into my issues. I started with a fresh build on my pi yesterday and installed Crowsnest before Tailscale and it worked. Now I’m having issues getting my camera to output to mainsail. I am new to multiple instances of klipper. Do I still need to create a webcam.Txt file? Or does it configure that in the Crowsnest configuration on mainsail interface?
I did not have any issues when I was running one instance. Just plugged in the camera and it worked. I have another camera coming in the mail for my second printer.
icy torrent
Here is the catch with multi instance. corwsnest does not support them activly. But configuration is done via a single file
All cams have to be placed in crowsnest.conf
For Mainsail extend the URL with the full DNS or IP
See this post on how to setup for multi instances
nimble viper
Got it sorted thank you for the help! That was a learning curve.