I’m thinking now that the cable mod might’ve be pulling the carriage back as the slight tension causes my CR probe that’s located behind it angle downwards causing it to come closer to the bed, I’ll be removing it and see if it improves.
#Bed Mesh not Meshing 🥲
hollow delta
hollow delta
Unfortunately I got the same results ðŸ«
hollow delta
hollow delta
hollow delta
These are my input shaper graphs but I’m currently learning how to read them and what they mean, I’m thinking I gotta go back to my 5k prints.cfg, I think this problem has surfaced due to my 10k settings in it, just horrendous vibration’s printing high speeds 🥲
hollow delta
Reduced the speeds and still the same issue lol probably gonna build my other one and rebuild this entire thing in the future, sucks that I was printing fine before and all of the sudden it’s just acting up so bad
hollow delta