timber jetty
This is a low profile filament sensor meant to go on the outside of nebula and use a D2F micro switch with the lever removed completely.
BOM:
4x M3 heat sets
4x M3 x 6BHSC
1x M3 x 20 BHSC (mileage may vary)
1x D2F Micro switch
1x JST Xh 2.54 3 Pin thru veritcal
2x PC4 M10 fittings
Remove center pin on both the D2F switch and 3 pin connector, bed the two outside pins inward on the D2F switch and bend the pins outwards and downwards on the jst 3 pin outside pins so they can meet properly inside the housing.
Solder in place.
Use super glue to keep the micro switch pushed as far forward as you can push.
