Hi! from trouble to trouble and solving somehow all of them thank to you all. I am close to finish ,only a probe issue. I am using BIQU microprobe, but when switching on the printer it tests three times properly and ends deployed. After that if never stows, even if you power off with the probe deployed and power on again, you can se how it tries to stow with no success. But, if yoou stow manually the probe and restart again, it does the same , tests properly three times ends in deployed status and back to the same behaviour, blocked deployed....
#Problems with BIQU microprobe
ashen yacht
ashen yacht
Well....Problem was Orbitool, directlyu to the Motherboard, everything fine.... even it obeys to commands. Anyhoy it does not stop when homing, but I am too tired... tomorrow will be another day
ashen yacht
Update. Connected to the motherboard everything fine. Responds to commands and endstop query properly. But one last thing, when homing bed does not stop when touching the probe. If i slightly press the probe with my finger before bed arrives , it does. Probe deployed is about 2mm below nozzle , should I allow more distance to leave bed add more pressure?
ashen yacht
Moved back to my old BL Touch , now working from the MoBo everythiong works fine. Returning Microprobe 🙂
inner rover
I'm curious what control board you're using. I could not get my micropro V2 to work properly using an octopus board. I've also found link suggesting that it's not compatible with octopus. So I stopped trying.