higher belt comes loose after a print | Zero G | Page 1

north vault Apr 7, 2024, 7:37 AM

#

After a print on lower belt I have 110 HZ, but on lower it is 100HZ and before print both were 110HZ. What incorrect in the build could cause this belt to loose?

#

Because of it I get layer shifts that look like that

#

I know that this is only higher belt because layers are changing in the direction controlled by higher belt

north vault Apr 7, 2024, 9:22 AM

#

May this be caused by cheaper belt?

grand sable Apr 7, 2024, 9:59 AM

#

So belts do stretch after printing for a little while, that's why it's important to check all screws and redo belt tension after 48 hours of printing, I'd say. Once the belts are stretched to where they're stable, you're all good 👍

north vault Apr 7, 2024, 10:12 AM

#

So I should just print until they stabilize?

#higher belt comes loose after a print