cursive tree
My frame finaly arrived and I have started my build.
This is a complete build, meaning everything is new and I don`t use parts from a donor printer.
HW:
Frame: Tall warm thing
EVA 2.4
Leadscrews T8/2 with POM nut.
Rapido HF hotend
LDO Orbiter v2
BTT Octopus Pro v/TMC2209
BTT Pi v1.2
BTT U2C V2.1
BTT EBB36
SSR
BTT 360W power supply
Fysetc 255 Bed with 220V/600W heater (Kit)
Klicky mod
Sexbolt (unsure how to mount this on the Hydra stil ?)
3x WobbleX (WS8)
last harbor
Interested in out come of your build. And wobble z review
cursive tree
I use WobbleX on my dual Z Merc1 (E5Pro) and is happy with it so far, have not tried Oldham coupler so I have nothing to compare it to tho.
cursive tree
Finally some progress. 
Been waiting for parts (and screws 😀) while I’m been waiting I have setup klipper and the Can bus. Flashing firmware etc…
cursive tree
Gluing heat pad to the bed, 600w/220v (Fysetc 255 kit)
cursive tree
Z stepper cables done ✅
cursive tree
Now only belts and panels left. But it’s been a long day so that have to wait until tomorrow 🤔 After that it’s on to the configs.
cursive tree
Almost done!!
Running calibration prints Flow, extution etc
Stil looking for led bar and a Bowden solution to pass through the panel top or back.
narrow iron
@cursive tree I like that a lot. Nice work
cursive tree
<@277092363812339712> I like that a lot. Nice work
thx. I could do alot better with cable management tho. But overall I`m happy with it.
narrow iron
thx. I could do alot better with cable management tho. But overall I`m happy wit...
That's something that can always be improved. I'm fighting that battle now too
narrow iron
thx. I could do alot better with cable management tho. But overall I`m happy wit...
I feel like it's a reoccurring theme here. I'm struggling with my wire management lol