I was having trouble getting ABS to stick to glass. Today I realized I am having severe under extrusion. I changed the nozzle, checked the extruder gears and checked e-steps. Doesn't appear to be any of these. Not really sure where to go from here.
#Under extrusion
blazing thorn
The purge line looks fine. When I give the consol the command to extrude X amount, it does
tried varying cura profiles, no difference
blazing thorn
trammed the bed, set z-offset, and auto leveled
blazing thorn
tried cranking up the temp by 40. Celsius
completely stumped
I want to say that there is something wrong with the extruder but the purge line looks fine. So, it must either be cura or printer.cfg
e-steps were spot on..
cranked the flow up to 130% and it looks better but that feels like an odd solution
result of cranking up the flow to an absurd percentage
blazing thorn
replaced the thermistor, no difference
blazing thorn
cleaned the gears with ipa
blazing thorn
I feel like I have completely ruled out the extruder
blazing thorn
SOLVED