gilded grotto
Build log and general ranting. Had an old E5+(first printer) collecting dust, and in need of work to bring it back up to spec. Picked up the kit from fabreeko, and printed all the parts I felt like I needed. Building it with what hardware I had in/on the printer originally. And will probably modify more as time goes on. Currently have an E3D valcano, ordered and orbiter 2.0, has a BTT 1.4 Turbo.
State of printer at start and then stripped
Aparently had an issue with dowel size and one side snapped
Put another pair on to print and carried on
Installed remainder of motion system with part of the toolhead. Added legs and front grill for test fit.
Thats it for today. Might be a few days before I can continue work on it.
gilded grotto
I have been convinced of crimes https://cdn.discordapp.com/attachments/899682644365820014/1131283312581824512/image.png
gilded grotto
It has arived
gilded grotto
And finished the feet and grates
gilded grotto
Added the shroud, but looks like I need to figure out where to put the motion board, it does not fit with this setup (hotend build)
gilded grotto
gilded grotto
Ok long time no see, life happened
Since the last post, nothing has happened untill today, sat quietly in a corner.
So things that have happened today, I took baby out of the corner and set it up on a folding table in the middle of the garage so I cant walk past it, and started screwing with elelectronics.
Started stripping the old electronics enclosure, boy was my old mout warped
Then relised I did not have the rails for the bottle anywhere I could find... screw it I will mount the old enclosure upside down for now I thought. Lets just get this to minimal viable for now.
Thats when I realized... the stock wireing I was mostly planning on using will not work... at all
I was not planning on using a can-bus, and dont know if any will work with my SKR E3 Turbo, may need to upgrade board as well.
