Ok so my esteps have been calibrated (ask for 100mm get 100mm) EM is good (ask for .4 line width get .4 line width) but for the life of me I can figure out why I can’t fix these line gasp any help is greatly appreciated.
#Gaps between walls, not sure how to fix this
stray sluice
lapis tapir
If it was me, I'd check flow and z offset/ on first layer
stray sluice
Yeah flow is dead on .4 like it should be. Bed level is good, this printer doesn’t have any ABL probe. It’s odd though even in the slicer it seems to have those gaps when I preview it.
stray sluice
im not sure for line overlap, i dont see that cura anywhere not sure what its called in there. yeah my cubes have all came out spot on.
wanton isle
Try increasing your Extrusion multiplier by 5%, see if it helps, if it does tune it from there
There's also a setting to have Kira compensate line with, check that three slice it see if the gaps go away, sometimes I don't like to use that I manually increase and decrease my multiplier
You have to remember it's trying to produce 4 mm line width if your part is not a multiple of that something has to give
stray sluice
There's also a setting to have Kira compensate line with, check that three slice...
I hadn’t even thought about the issue of it being a multiple or not before. I’ll definitely give that a try. I turned my heat up some and it seemed to help a good bit.
grizzled steppe
0.25